E-flite Beechcraft Staggerwing 480 ARF - Manual (Page 26)

26 E-flite Beechcraft Staggerwing 480 ARF Assembly Manual
To land the airplane, enter the pattern parallel with
the runway and reduce power. Once the airplane
has slowed down, add a notch of flaps, and if your
airplane is equipped with the micro pneumatic retracts,
don’t forget to extend your gear! Fly the airplane
around and line up with the runway. When you’re
over the runway threshold, chop the power and fly it
down. Once you get in ground effect, begin to flare
and you’ll find that the airplane will settle down nicely.
Both wheel landings and full-stall landings are within
the capabilities of this bird.
That’s it, you’ve just successfully flown your new E-flite ®
Beechcraft Staggerwing 480! We wish you many
enjoyable flights with it!
Daily Flight Checks
 1. Check the battery voltage of the transmitter
battery. Do not fly below the manufacturer’s
recommended voltage. Doing so can crash
your aircraft.
When you check the batteries, ensure that you have
the polarities correct on your expanded scale voltmeter.
 2. Check all hardware (linkages, screws, nuts, and
bolts) prior to each day’s flight. Be sure that binding
does not occur and that all parts are properly
secured.
 3. Ensure all surfaces are moving in the
proper manner.
 4. Perform a ground range check before each day’s
flying session.
 5. Prior to starting your aircraft, turn off your
transmitter, then turn it back on. Do this each time
you start your aircraft. If any critical switches are on
without your knowledge, the transmitter alarm will
sound a warning.
 6. Check that all trim levers are in the
proper location.
 7. All servo pigtails and switch harness plugs should
be secured in the receiver. Make sure the switch
harness moves freely in both directions.
Limited Warranty
WhAT ThIS WARRANTy COVERS
Horizon Hobby, Inc. (“Horizon”) warrants to the
original purchaser that the product purchased (the
“Product”) will be free from defects in materials and
workmanship at the date of purchase.
WhAT IS NOT COVERED
This warranty is not transferable and does not cover
(i) cosmetic damage, (ii) damage due to acts of God,
accident, misuse, abuse, negligence, commercial use,
or due to improper use, installation, operation or
maintenance, (iii) modification of or to any part of the
Product, (iv) attempted service by anyone other than
a Horizon Hobby authorized service center, or (v)
Products not purchased from an authorized Horizon
dealer.
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS ANY
AND ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE.
THE PURCHASER ACKNOWLEDGES THAT THEY
ALONE HAVE DETERMINED THAT THE PRODUCT
WILL SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER’S INTENDED USE.
pURChASER’S REMEDy
Horizon’s sole obligation and purchaser’s sole and
exclusive remedy shall be that Horizon will, at its
option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective. Horizon
reserves the right to inspect any and all Product(s)
involved in a warranty claim. Service or replacement
decisions are at the sole discretion of Horizon. Proof
of purchase is required for all warranty claims.
SERVICE OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE PURCHASER’S SOLE AND
EXCLUSIVE REMEDY.