E-flite Beechcraft Staggerwing 480 ARF - Manual (Page 12)

12 E-flite Beechcraft Staggerwing 480 ARF Assembly Manual
 15. Repeat steps 12 through 14 to install the
remaining retract.
horizontal Stabilizer Installation
Required parts
Fuselage Top wing
Stabilizer
3mm x 25mm shoulder machine screw (2)
Required Tools and Adhesives
Medium CA Phillips screwdriver: #1
 1. Fit the top wing into position on the fuselage,
guiding the pins at the font of the wing into the fitting
on the fuselage.
 2. Use two 3mm x 25mm shoulder machine screws to
attach the wing to the fuselage. Make sure the aileron
lead is inside the fuselage.
 3. Place the stabilizer on the fuselage. Step back
8–10 feet (2–3 meters) and check that the stabilizer is
aligned with the top wing as shown.
NOTICE: Do not use a CA accelerator during
the assembly of your model. A CA accelerator will
damage the finish of your model and can damage
the foam as well. Even foam-safe accelerators will
damage the finish of your model. Allow the CA to
cure without the use of an accelerant.