E-flite Beechcraft Staggerwing 480 ARF - Manual (Page 21)

21 E-flite Beechcraft 480 Staggerwing 480 ARF Assembly Manual
 2. Install the air tank in the fuselage. Use a very
small amount of silicone adhesive to keep the air
tank from moving in the fuselage. Don’t over-glue
the air tank in case it requires removal in the future.
Final Assembly
Required parts
Fuselage assembly Top and bottom wing
Antenna (2) Interplane strut (2)
3mm x 25mm shoulder machine screw (4)
2mm x 7mm self-tapping washer-head screw (4)
Required Tools and Adhesives
Medium CA Hobby knife with #11 blade
Phillips screwdriver: #1
 1. Locate the hole for the screw mount underneath
the decal and use a hobby knife and #11 blade
to remove the decal, exposing the location for the
interplane strut screws.
 2. Position the bottom wing on the fuselage. Guide
the flap servo lead (and retract servo lead) through
to the receiver in the fuselage. Screw the quick
disconnect valve together tightly. If it is not screwed
together tightly, air will leak and the system will not
hold pressure.
 If you have installed retracts, make
sure to connect the air lines from the
wing and air tank, and the retract
servo lead at this time as well.