E-flite Mini ShowTime 4D ARF - Manual (Page 27)

E-flite Mini ShowTime ARF Assembly Manual
  4. Install the micro control connector onto the
elevator servo arm. Pass the elevator pushrod wire
through the connector. With the radio on and elevator
trim centered, center the elevator. Secure the elevator
pushrod wire using the 2mm x 4mm screw and a small
Phillips screwdriver.
Note: The Mini ShowTime is designed to use an optional
pull-pull rudder linkage when using a lightweight motor
and battery. The items for the pull-pull system are
available separately.
 5. Repeat Steps 1 through 4 for the rudder servo and
linkage using the 5
5 /
8
-inch (143mm) pushrod wire.