E-flite Mini ShowTime 4D ARF - Manual (Page 14)

14 E-flite Mini ShowTime ARF Assembly Manual
 9. Enlarge the holes in the cowling ONLY using a
1 /
8
-inch (3mm) drill bit. Slide the cowling onto the
fuselage. Secure the cowling using four 2mm x 8mm
sheet metal screws.
Hint: Use thin CA to harden the holes drilled into the
cowl mounting tabs. This will help to prevent the screws
from vibrating loose in flight.
 10. Place the propeller back on the motor shaft
and tighten the adapter. Snap the spinner cone onto
the spinner.
Note: Make sure to check the balance of the propeller
after enlarging the hole in the propeller.