E-flite Mini ShowTime 4D ARF - Manual (Page 26)

E-flite Mini ShowTime ARF Assembly Manual
Rudder and Elevator Servos
Required Parts
Fuselage
Micro control horn w/backplate (2)
5-inch (127mm) pushrod wire
2mm x 4mm screw (2)
5
5 /
8
-inch (143mm) pushrod wire
Micro control connector w/retainer (2)
Carbon rod, 8-inch (204mm) (4)
Servo (2)
12-inch (305mm) servo extension (2)
Required Tools and Adhesives
Phillips screwdriver (small) Hobby knife
6-minute epoxy
 1. Secure an 18-inch (457mm) servo extension to the
servo. Mount the elevator servo using the hardware
provided with the servo.
Hint: It is easiest to pass the extension through the former,
then to the rear of the fuselage and retrieve it at the
opening for the servo.
 2. Use a hobby knife to enlarge the inboard hole
in one of the remaining control horns. Attach the
5-inch (127mm) pushrod wire to the control horn.
  3. Attach the micro control horn to the elevator using the
control horn backplate and 6-minute epoxy.