E-flite Mini ShowTime 4D ARF - Manual (Page 20)

0 E-flite Mini ShowTime ARF Assembly Manual
 8. Turn on the radio system and center the aileron trim
and stick. Make sure the aileron servo is operating
properly using the transmitter. Slide the pushrod wire
through the micro connector. Install the servo arm parallel
to the aileron hinge line. Center the aileron, and secure
the position of the wire using the 2mm x 4mm screw and
a Phillips screwdriver.
 9. Use side cutters to remove any excess wire, leaving
about
1 /
4
(5mm) excess wire past the control connector.
Wing Installation
Required Parts
Fuselage Wing (right and left)
Wing tube #4 washer (silver) (2)
4-40 x 1 / 2
-inch socket head screw (2)
Required Tools and Adhesives
Hex wrench: 3 / 32
-inch
6-minute epoxy Pliers
 1. Slide the wing tube into a wing panel.
 2. Remove the hatch from the bottom of the fuselage
using a
3 /
32
-inch hex wrench.