E-flite Pitts Model 12 15e ARF - Manual (Page 30)

30 E-flite Pitts Model 12 15e ARF Assembly Manual
Final Detail Installation
Required Parts
Fuselage Air Intake
Plywood aileron horn (4) Clevis (2)
Pushrod connector (2) 2mm x 10mm machine screw (5)
2mm nut (5) 2mm x 8mm sheet metal screw (2)
Lower fin extension
7
3 /
4
-inch (197mm) pushrod wire (2)
Required Tools and Adhesives
Medium CA Hobby knife
Canopy glue Tape
 1. Use medium CA to glue the air intake to the bottom of
the fuselage. Make sure not to glue the intake to the cowl.
Note: Your intake scoop will differ slightly from the one
pictured above. It will be black in color as well, not white
as depicted in the photo. These changes were made to
ensure the accuracy of the full scale Pitts model 12 was
maintained.
 2. Install the pushrod connector in the bottom control
horn. The screw will face toward the wing tip.
 3. Thread a clevis on the pushrod wire. Connect the clevis
to the control horn of the top wing. With both ailerons
centered, tighten the screw to secure the pushrod to the
pushrod connector.