E-flite Pitts Model 12 15e ARF - Manual (Page 21)

21 E-flite Pitts Model 12 15e ARF Assembly Manual
Radio Installation
Required Parts
Control horn (4) Control horn backplate (4)
Pushrod wire clip (4) Aileron servo block (4)
Clevis (4) Long servo arm (2)
3mm x 30mm machine screw (2)
2mm x 6mm sheet metal screw (8)
3
3 /
4
-inch (95mm) pushrod wire (4)
Required Tools and Adhesives
Drill Drill bit: 1/16-inch )1.5mm)
Hobby knife Servo (4)
Felt-tipped pen Pliers
Pin drill Phillips screwdriver: #0
Side cutters Thin CA
30-minute epoxy Drill bit: 5/64-inch (2mm)
9-inch (228mm) servo extension (2)
  1. Secure a 9-inch (228mm) servo extension to the servo
lead as shown. Use a commercially available connector
or some thread to secure the connection.
  2. Remove the covering for the opening for the rudder
servo. Use the hardware provided with the servo to install
it in the fuselage.