E-flite Pitts Model 12 15e ARF - Manual (Page 17)

17 E-flite Pitts Model 12 15e ARF Assembly Manual
 2. Carefully bend the tail wheel assembly as shown in
the image. Use side cutters to remove the excess wire
as shown below.
 3. Use a pin vise and 5/64-inch (2mm) drill bit to drill a
hole into the rudder 7/8-inch (22mm) up from the bottom
of the rudder.
 4. Use a hobby knife to cut a groove from the hole to the
bottom of the rudder. This will recess the tail gear wire
when it is glued to the rudder.
 5. Slide the tail wheel bracket onto the tail gear assembly.
Use 6-miniute epoxy to glue the tail wheel assembly into
the rudder. Use tape to hold the wire in position until the
epoxy fully cures.