E-flite Pitts Model 12 15e ARF - Manual (Page 25)

25 E-flite Pitts Model 12 15e ARF Assembly Manual
 13. Use 30-minute epoxy to glue the aileron servo blocks
to the servo cover as shown.
 14. Position the servo between the blocks. Make sure
there is a slight gap between the servo and cover, then
drill the locations for the servo screws using a 1/16-inch
(1.5mm) drill bit and drill.
 15. Install a long servo arm on the servo after centering
it using the radio system. Secure the servo using the
hardware provided with the servo.
Note: Please sand the mount blocks down to where they
are flush with the servo. There will be a slight hump in
the covering when the servo is installed.
 16. Tie the string to the servo lead.