E-flite Pitts Model 12 15e ARF - Manual (Page 13)

13 E-flite Pitts Model 12 15e ARF Assembly Manual
Note: Please use threadlock on all wing strut screws and
nuts in the following steps.
Note: You will find the holes larger than 2mm on the
attachment fittings for the wing struts. This enables you
to adjust the wings slightly so as to not create any warps
when you tighten the screws down.
 8. Attach the struts to the bottom wing using four
2mm x 10mm machine screws, four 2mm washers
and four 2mm nuts.
 9. Position the top wing. The tabs at the cabane struts
(center of the wing) of the wing will be on the outside of
the cabane struts. Secure the outer struts to the top wing
using four 2mm x 10mm machine screws, four 2mm
washers and four 2mm nuts.
 10. Secure the cabane struts to the top wing using four
2mm x 10mm machine screws, four 2mm washers
and four 2mm nuts.