E-flite Aeronca Champ 15e ARF - Manual (Page 6)

6 E-flite Aeronca Champ 15e ARF Assembly Manual
 7. Position the servo on the cover, using the lines
drawn in Step 5. Adjust the position of the servo so
the servo horn is positioned center in the opening
as shown.
 8. Use a pencil to mark the position of the servo
next to the brass eyelets. Make sure not to move the
servo when marking the servo cover.
 9. Position the block on the cover near the rear of
the cover. It will be necessary to notch the block to
fit over the tab that secures the rear of the cover.
Position the block against the tab and use a pencil
to draw a line on the block to determine how much
to remove.
 10. With the block positioned on the marks made
for the servo, use a pencil to mark the block for
the amount required to be removed so it can fit
over the tab.
 11. Use a sanding block or razor saw to remove
the material necessary from the block to fit over the
tab when the block is positioned on the cover for
mounting the servo.
 12. Use 6-minute epoxy to glue the servo blocks to
the servo cover. Use clamps to hold the blocks in
position until the glue fully cures.