E-flite F-16 400 DF ARF - Manual (Page 26)

26 E-flite F-16 ARF Assembly Manual
Motor Battery Installation
High-Power Ducted Fan Installation
Required Parts
Motor battery Assembled airframe
Hook and loop tape
 1. Apply the hook and loop tape to the bottom of
the battery. Use the softer fabric side of the hook
and loop tape on the battery.
 2. Apply the hook and loop tape inside the
fuselage in the battery compartment. Use the
harder plastic side of the hook and loop tape on
the battery.
 3. Place the battery into the battery compartment
in the fuselage. The battery will be positioned in
the compartment to achieve the correct Center of
Gravity when you are using the recommended
setup. The forward end of the battery should just
clear the nose wheel steering arm.
Missile Installation (Optional)
Required Parts
Missile (2) Assembled airframe
Required Tools and Adhesives
Medium CA
Note: The installation of the missiles on your
model is not scale for this paint scheme and
is considered optional. The missiles will be
attached permanently and will not affect the
flight performance.
 1. Locate the missile included with your model.
Inspect each missile to locate the flat areas between
the fins of the missile. These flat areas are the
gluing surfaces used for their installation.