E-flite F-16 400 DF ARF - Manual (Page 11)

11 E-flite F-16 ARF Assembly Manual
 8. Connect a 9-inch (228mm) (Sport Ducted Fan)
or 12-inch (305mm) (High-Power Ducted Fan)
servo extension to the lead on the elevator servo.
Tie a piece of string or dental floss around the
connection to prevent the two from unplugging
accidentally. Install an extension for both elevator
servos at this time.
 9. Connect a 3-inch (76mm) (Sport Ducted Fan)
or 6-inch (152mm) (High-Power Ducted Fan)
servo extension to the lead on the aileron servo.
Tie a piece of string or dental floss around the
connection to prevent the two from unplugging
accidentally. Install an extension for both aileron
servos at this time.
 10. Carefully lay the extension from the elevator
servos into the channel on each side of the
fuselage. The aileron extension will than be placed
on top of the elevator extension. Both extensions
are then inserted into the fuselage where the
channel turns to enter the fuselage.
Before inserting the extension leads through the
fuselage, mark each lead according to which servo
it is connected to. (Right Elevator, Left Elevator-this
will help with set up later). You can use a small
felt-tipped marker or a piece of tape for this.
 11. Locate the decal to cover the channel for the
aileron and elevator extensions. A right and left
decal has been supplied to cover the channels.
Make sure to use the correct decal on each side of
your aircraft.
 12. Remove the backing from the decal. Starting
at the front, hold the rear of the decal up and
align the trim scheme from the decal to the
scheme on the aircraft. Carefully work toward
the rear of the fuselage, pressing the decal down
and guiding the extensions under the decal to
remain in the channel.