E-flite F-16 400 DF ARF - Manual (Page 22)

22 E-flite F-16 ARF Assembly Manual
 4. Plug the extensions from the ailerons and
elevators into the proper ports of the receiver.
Also plug the lead from the steering servo and
speed control into their proper ports on the
receiver as well.
 5. Use a small piece of hook and loop tape
to mount the receiver in the fuselage as shown.
The edge of the receiver should be flush with
the edge of the cockpit opening as seen in the
following step.
Receiver Location
 6. Use a small piece of hook and loop tape to
mount the remote receiver alongside of the steering
servo. Make sure the position of the remote receiver
will not interfere with the operation of the steering
servo when it is installed.
Speed Control and Receiver Installation
High-Powered Ducted Fan Installation
Required Parts
Speed control Assembled airframe
Receiver Hook and loop tape
3-inch (76mm) servo extension
Required Tools
Pin drill Drill bit: 1/8-inch (3mm)
Note: Due to the current draw of the system
and the location of the electronics, we
recommend that throttle management is used
during each flight. Using full power throughout
the duration of the flight will result in shorter
flight times and could result in a shorter life
span for the electronics and batteries.
 1. Plug the wires from the speed control and motor
together. The wires from the motor will be just long
enough that they can be accessed from the cockpit
area of your model.