E-flite Sobre 3D Profile - Manual (Page 27)

E-flite Sobré 3D Profile Assembly Manual
  3. Glue the bottom SFG into position. Glue the
4.3-inch (110mm) carbon rod to the SFG. Check
that the top and bottom SFGs are still perpendicular
to the wing. Use Foam-compatible CA to glue the
carbon rods to each other and to the wing.
 4. Repeat Steps 1 through 3 for the remaining upper
and lower SFG installation.
Battery Installation
Required Parts
Battery
Hook and loop tape
 1. Use hook and loop tape to secure the battery to
the underside of the wing. The location of the battery
can be adjusted to correct for the Center of Gravity
described later in this manual.