E-flite Sobre 3D Profile - Manual (Page 19)

1 E-flite Sobré 3D Profile Assembly Manual
 1. Locate the plywood motor mount and aluminum
X-mount for your particular motor. Center the motor
mount on the plywood and mark the holes for the
mounting screws using a felt-tipped pen making sure
the holes you mark do not interfere with the carbon
spars the mount will glue into.
Hint: If the hole in your mount matches the diameter of
the hole in the plywood mount, use a rolled-up piece
of cardstock placed through the two holes to center the
motor mount on the plywood mount.
 2. Drill pilot holes for the mounting holes marked
on the plywood mount using a
1 /
16
-inch (1.5mm)
drill bit.