E-flite Sobre 3D Profile - Manual (Page 21)

1 E-flite Sobré 3D Profile Assembly Manual
 6. Place the plywood motor mount in position.
Make sure the mount is tight against the vertical and
horizontal fuselage. Trim the fuselage as necessary
to provide clearance for the motor leads. Use Foam-
compatible CA to securely glue the mount to the
vertical and horizontal fuselage.
 7. Solder any necessary connectors to your speed
control. Plug the speed control into the throttle channel
of the receiver and to the motor. Use hook and loop to
secure the speed control to the fuselage.
Note: It is suggested to secure the motor wires to the
fuselage to prevent them from coming in contact with the
propeller or servos when performing extreme maneuvers.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also,
be sure to use an ESC with the proper 9V cutoff when
using 3-cell Li-Po packs, or 6V cutoff when using 2-cell
Li-Po packs.