E-flite Sobre 3D Profile - Manual (Page 17)

1 E-flite Sobré 3D Profile Assembly Manual
  9. Locate the 4.5-inch (115mm) pushrod. Install
the “Z” bend into the middle hole of the control
horn that is one away from the aileron. Pass the
pushrod through the connector. Check that the
aileron servo is centered using the radio and
parallel to the aileron hinge line. Hold the aileron
parallel to the wing and use the 2mm x 4mm screw
in the connector to secure the pushrod wire. Repeat
for the other aileron pushrod.
Note: Use the hole in the control horn closest to the
aileron for the greatest amount of throw. Moving the
pushrod outward, away from the aileron, will result in
gradually decreasing the control throws.
 10. Install the 19.25-inch (490mm) pushrod for the
rudder, and the 18.5-inch (470mm) pushrod for the
elevator. The rudder pushrod goes under the stabilizer
brace and on the outside of the fuselage bracing.
Don’t forget to check to make sure the servos and
control surfaces are centered before tightening the
2mm x 4mm screws. Slide the pushrod braces into
the notches in the fuselage so the pushrods can move
freely. Use Foam-compatible CA to glue the pushrod
guides to the fuselage.