E-flite Sobre 3D Profile - Manual (Page 26)

E-flite Sobré 3D Profile Assembly Manual
Installing the Optional
Side Force Generators
Required Parts
Side force generator (upper) (2)
Side force generator (lower) (2)
Carbon rod, 4.3-inch (110mm) (4)
Required Tools and Adhesives
Foam-compatible CA
Square
Note: The side force generator (SFG) installation is
optional. If you plan on saving weight, or flying from
very rough surfaces, it is suggested to skip this section.
  1. Locate the upper side force generator. Position
the SFG on the wing, aligning it with the two holes
that have been pre-drilled in the wing. Use a square
to position the SFG perpendicular to the wing. Use
Foam-compatible CA to glue the SFG to the wing.
  2. Locate a 4.3-inch (110mm) carbon rod. Position
the rod in the predrilled holes in the SFG and wing.
Use foam-compatible CA to glue the carbon rod to the
SFG ONLY at this time.