E-flite Sobre 3D Profile - Manual (Page 11)

11 E-flite Sobré 3D Profile Assembly Manual
 7. Place the motor mount in position to aid in the
alignment of the vertical and horizontal fuselage
pieces. DO NOT glue the mount until instructed to
do so. Position the horizontal and vertical fuselage
pieces until the mount rests flush against both.
 8. Apply foam-compatible CA to the joint between
the vertical and horizontal fuselage pieces from the
leading edge of the wing to the front of the fuselage.
Use a square to make sure the two pieces are
aligned. Apply CA to both the top and bottom of the
vertical fuselage.
 9. Complete gluing the vertical and horizontal
fuselage pieces together. Continue to use a square
to keep both pieces in alignment.