Banner SI-HG63 Hinge Style Switches - Manual (Page 5)

CAUTION: Abuse of Module After Failure
If an internal fault has occurred and the Module will not reset, do not tap, strike, or otherwise attempt to
correct the fault by a physical impact to the housing. An internal relay may have failed in such a man-
ner that its replacement is required.
If the Module is not immediately replaced or repaired, multiple simultaneous failures may accumu-
late such that the safety function can not be guaranteed.
Specifications
Contact Rating
3A @ 250V ac max., 0.5 A @ 60V dc max.
2.5 kV max. transient tolerance
NEMA A300 P300
European Rating
Utilization categories: AC15 and DC13 (IEC 90497-5-1)
Ui = 250V ac
Ith = 3A
Short Circuit Protection
6 amp Slow Blow, 10 amp Fast Blow. Recommended
external fusing or overload protection.
Wire Connections
4-pin Micro-style quick-disconnect (QD) fitting. Cables
are ordered separately; see Accessories.
Weight
0.40 kg (0.88 lb)
Minimum Switching Speed
20 operations per minute
Mechanical Life
1 million operations
Force Exerted by Guard per Switch
Axial: 750 N (165 lbf) max.
Radial: 1000 N (220 lbf) max.
Operating Range
0° to 180°
Construction
Zinc Die-cast (GD-Zn)
Environmental Rating
NEMA 4, IEC IP67
Operating Conditions
Temperature: -25° to +70° C (-13° to +158° F)
Application Notes: To avoid excessive radial stress in applica-
tions containing large doors, the hinge switch should be mounted
either in pairs of two, or in conjunction with a blank hinge (see
page 7). Certifications:
Dimensions
Model SI-HG80DQD Model SI-HG80DQDR
80.0 mm
(3.15")
64.0 mm
(2.52")
72.0 mm
(2.83")
15.0 mm (0.59")
11.0 mm (0.43")
16.0 mm (.63")
10.0 mm (0.39")
4.5 mm
(0.18")
10.0 mm
(0.39")
M12 x 1
19.0 mm
(0.75")
15.5 mm
(0.61)
4x 6.5 mm
(0.25")
2 x 10.5 mm
(0.41")
17.0 mm (0.67")
10.0 mm
(0.39")
23.6 mm
(0.93")
M12 x 1
Note: 18 mm Hole Recommended
19.0 mm
(0.75")
15.5 mm R9.0 mm
21.0 mm
(0.83")
11.5 mm
(0.45")
Hinge Wing Safety Interlock Switches
P/N 046735 Rev. C www.bannerengineering.com - tel: 763-544-3164 5