Banner WORLD-BEAM QS30 Clear Object Sensor - Manual (Page 7)

P/N 139760 rev. A
7
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
WORLD-BEAM
®
QS30ELVC Series
Remote Line TEACH
General Notes
• Connect the gray wire of the sensor to ground (0V dc), with a remote programming switch connected between them
• Run Mode is the sensor’s normal operating condition
• The duration of each Pulse is defined as “T”: 0.04 < T < 0.8 s
• A Hold will exit TEACH MODE and return to Run Mode with previously saved changes. The duration of a Hold is: T > 2 s
• A Timeout will occur if a condition is not registered within 60 seconds, causing the sensor to return to Run Mode (during sensor configuration only)
• Sensor configuration user feedback shown on Green LED. See flow chart below. T
T
T
T
T
T T
T T T
T T
T T
T
T T
T T
T
Light SET
Basic Configuration Menu
LO
DO (default)
8%
16% (default)
Advanced Sensor
Configuration Menu
Push button
enabled (default)
Push button
disabled
Auto. comp.
enabled (default)
Auto. comp.
disabled
Push button enable /disable
(legacy method )
Restore factory defaults
Run Mode
1x
2x
3x
4x
8x
1x
3x
2x
4x
1x
2x
3x
4x
Power LED OFF,
Red Signal LED Flashing
Power LED OFF
LO and current threshold LEDs Flashing
Power LED OFF
Auto LED Flashing
Flash Power:
1x for enabled , Repeat twice
2x for disabled, Repeat twice
All LEDs off for 1 s
LO LED ON
LO LED OFF
Clear Bottle
Medium Bottle
Flash Power 1x,
Repeat twice
Flash Power 2x,
Repeat twice
Auto LED ON
Auto LED OFF
Power LED ON,
All other LEDs in normal
operating condition
Exit
60 second Timeout
2 s Hold
2 s Hold
5x
32% Dark Bottle
60 second Timeout