Banner WORLD-BEAM QS30 Clear Object Sensor - Manual

WORLD-BEAM
®
QS30ELVC Series
Expert™ Clear Object Non-Polarized Retroreflective Sensor
Printed in USA 01/09 P/N 139760 rev. A
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A
sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner
Safety Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
Features
Reliable detection of clear, translucent, or opaque targets — including mirror-like •
surfaces
Automatic compensation algorithm compensates for dust or contamination on the
•
sensor or reflector and for ambient temperature changes
3 selectable thresholds based on type of target being detected
•
Easy configuration via push buttons or remote wire •
Easy-to-read operating status indicators •
Rugged housing for harsh environments; rated IP67 (NEMA 6), 1200 psi washdown •
per NEMA PW12
Compact housing, mounting versatility — 30 mm threaded barrel or side-mount
•
Models
Model Sensing Range and Use* Cable** Supply Voltage Output
QS30ELVC
100 mm to 2 m (3.9" to 78")
Light SET for clear object detection
2 m (6.5') 5-wire cable
10 to 30V dc Bipolar (NPN and PNP)
QS30ELVCQ Integral 5-pin Euro-Style QD
* Operation at shorter and longer distances possible. Contact factory for applications assistance.
** For 9 m (30') cable, add suffix “W/30” to the model number (e.g., QS30ELVC W/30).
For 150 mm (6") pigtail with a 5-pin Euro-style connector, add suffix “Q5” to the model number (e.g., QS30ELVCQ5).
For 150 mm (6") PUR cable with 5-pin threaded Euro-Style QD, add suffix “QPMA” to the model number (e.g. QS30ELVCQPMA).
A model with a QD connector requires a mating cordset (see page 9).
RETRO
CLEAR PLASTIC