Banner WORLD-BEAM QS30 Clear Object Sensor - Manual (Page 5)

P/N 139760 rev. A
5
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
WORLD-BEAM
®
QS30ELVC Series
SETUP Mode
SETUP mode is used to change sensor configuration:
• Light or Dark operate
• Enable or disable automatic compensation algorithm
If SETUP mode programming is interrupted and remains inactive for 60 seconds, the
sensor returns to RUN mode with the most recent settings (i.e., exits and saves current
selection).
SETUP mode operates in the “background”, while the outputs are active; changes are
updated instantly.
The sensor can be configured using the remote line (see page 7).
Push Button
0.04 seconds ≤ “Click” ≤ 0.8 seconds
Result
Access
SETUP
Mode
• Press and hold both push buttons > 2 seconds
Green Power LED: OFF
Amber Output LED: Remains active
Bargraph: Status indicators (LO and AUTO)
flash current setup
Select
Setting
Combination
• Click either push button until LEDs show desired settings Sensor rotates through four setting combinations, in the
following order:
Return
to
RUN
Mode
• Press and hold both push buttons > 2 seconds
Green Power LED: ON
Amber Output LED: Remains active
Bargraph: Indicates current setup
• Sensor returns to RUN mode
with new settings
or
or
or
Setting Combination Auto LED LO LED
Auto Compensation ON/DO* ON OFF
Auto Compensation ON/LO ON ON
Auto Compensation OFF/LO OFF ON
Auto Compensation OFF/DO OFF OFF
* Factory default setting