Banner SureCross DX80 Wireless Networks - Manual (Page 5)

Modbus RTU with Multiple Slave Devices
In the example host controlled configuration, the Gateway is a Modbus slave to the host system, but remains the master
of the wireless network.
The Gateway is connected directly to the host system using an RS-485 serial cable. This system may also connect DX85
Modbus RTU Remote I/O devices to the serial cable to expand the available I/O. The Gateway and each DX85 connected as
shown below are Modbus slave devices to the host system.
Purpose: This wireless network also collects I/O data and sends it back to a Modbus host system, but adds local wired I/O
points.
Fieldbus Connection
Modbus Slave 2 Modbus Slave 3
2 2
1
Modbus Slave 1
Wireless Network
Host System
(Modbus Master)
Item Model No. Description
1 DX80G... DX80 or DX80 Performance Gateway
2 DX85M... DX85 Modbus RTU Remote I/O
3 MQDC1-5*** Cable, RS-485, quick disconnect 5-pin Euro, female single end, lengths vary
(not shown)
System Layouts
Datasheet www.bannerengineering.com - tel: 763-544-3164 5