Metrohm 930 Compact IC Flex ChS/Deg - Manual (Page 30)

3.5 Connecting the eluent bottle
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
22 ￭￭￭￭￭￭￭￭
930 Compact IC Flex ChS/Deg (2.930.1260)
￭ Place the loose end of the eluent aspiration tubing into the aspira-
tion filter.
The end of the tubing should reach approximately to the center of
the aspiration filter.
￭ Tighten the aspiration filter to the filter holder.
Figure 8 Installing tubing weighting and aspiration filter
3 Installing the eluent bottle cap on the eluent bottle
￭ Insert the eluent aspiration tubing into the eluent bottle
(6.1608.070).
￭ Tighten the bottle cap on the eluent bottle.
￭ Adjust the length of the eluent aspiration tubing so that the aspi-
ration filter is at the bottom of the eluent bottle. Then fasten it in
place using the M8 tubing nipple.
￭ Seal the M6 opening on the bottle cap with the M6 threaded
stopper from the accessory set.