Metrohm 828 IC Dual Suppressor - Manual (Page 17)

1.5 Safety notes
828 IC Dual Suppressor/ 8.828.1003 Instructions for Use
9
1.5 Safety notes
Warning!
This instrument should only be used in accordance with the
information given in these Instructions for Use.
1.5.1 Electrical safety
Electrical safety when handling the 828 IC Dual Suppressor is
guaranteed within the scope of Standard IEC 61010. However, please
observe the following points:
• Mains connection
The mains connection and checking the mains fuse must be
carried out according to the information given in Section 2.3.
• Opening the 828 IC Dual Suppressor
If the 828 IC Dual Suppressor is connected to the mains supply then it
must neither be opened nor should any parts be removed from it, as
otherwise the risk of contact with current-carrying assemblies exists.
This is why the instrument should be separated from all voltage
sources before being opened. Please make sure that the mains
cable is pulled out from mains connector 16!
• Protection against electrostatic charges
Electronic components are sensitive to electrostatic charges and can
be destroyed by a discharge. Before touching any assembly within
the 828 IC Dual Suppressor you should ground yourself and any tool
you are using by grasping a grounded object (e.g. the instrument
housing or a radiator) in order to eliminate any electrostatic charge
which may be present.
1.5.2 General safety measures
• Liquid handling
Check all inlet and outlet tubing for leaks at regular intervals. Observe
the appropriate regulations concerning the handling of flammable
and/or toxic solutions and their disposal.