Metrohm 828 IC Dual Suppressor - Manual (Page 14)

1 Introduction
828 IC Dual Suppressor/ 8.828.1003 Instructions for Use
6
Figure 3: Rear panel of the 828 IC Dual Suppressor
13 RS 232
Interface for service purposes
18 Ready Output
6-pin connector, used as fault switch,
carries status signals (ready/not ready)
to external instruments.
14 CO
2
Trap Cartridge
Holder for CO
2
absorber-cartridge for
cleaning the incoming air
19 Type and serial number
15 Remote switch
Activates the remote control of the
Dual Suppressor via the Remote
connector:
I = ON 0 = OFF
20 Drain
Drain port outlet for liquids
16 Fuse holder
For slow blow fuse 1.0 AT, U.600.0016
Mains switch
For switching instrument on/off:
I = ON 0 = OFF
Mains connector
For mains connection see Section 2.3
21 Remote
Remote interface for remote control by
external instruments.
17 Vacuum pump inlet
Connected to 6.2837.000,
see Section 2.2.1
22 Vacuum pump exhaust
13 14 15 16
18 19 20 21 22
17