Metrohm 846 Driver Toolbox - Manual (Page 23)

2.3 Error Messages
Dosing Interface USB Toolbox, DLL Reference 19
2.3 Error Messages
Error messages are presented in an array (Error number0…9), in which error
number 0 is always the most recent one. If more errors occur in a process,
more error entries are made. New errors always overwrite older ones, begin-
ning with index 0.
Error messages of the function GetInterfaceError :
Error message
XXX-NNN-A-I
XXX=error group, NNN=Code, A=class, I=Index (mostly MSB
number)
000-001-1-255 Process already exists
000-002-1-255 Process not found
000-003-1-255 Too many processes
000-004-1-255 Wrong node
000-005-1-255 Trigger not allowed
000-006-1-255 Wrong value
005-001-1-X Dosing device not found
005-002-1-X Dosing device used
005-003-1-X Check exchange/dosing unit
005-004-1-X Empty not possible
005-005-1-X Piston blocked
005-006-1-X Cock blocked
005-007-2-X Dosing rate was corrected
005-008-2-X Filling rate was corrected
005-009-2-X Dosing increment was corrected
005-010-3-X Dosing unit was plugged in
005-011-3-X Dosing unit was plugged out
005-012-2-X Dosing unit out during reading
005-013-2-X Dosing unit out during writing
005-015-1-X Dosing deving connected incorr.
007-001-1-X Stirrer not found
010-001-1-X Remote device not found
010-003-1-X Other devices at MSB
012-001-3-255 Manual stop of mode