Metrohm 846 Driver Toolbox - Manual (Page 14)

2.1 Constants
10 Dosing Interface USB Toolbox, DLL Reference
Status messages of a Dosino which are returned by the Status() function.
IDLE Dosino is ready to execute a function
FILL Cylinder is being filled
EXCHANGE Dosino is executing Exchange function
POSITION Dosino is executing GoPos function
ZEROADJUST Dosino is executing ZeroAdjust function
ADJUST Dosino is executing Adjust function
COCK Dosino is executing Cock function
TOENDDOS Dosino is executing ToEnd function
DOS Dosino is executing MakeStep function
PREPAR Dosino is executing Prep function
EMPTY Dosino is executing Empty function
BUSY Dosino is busy
HOLD_FILL Dosino is halted while filling
HOLD_EXCHANGE Dosino is halted in Exchange function
HOLD_POSITION Dosino is halted in GoPos function
HOLD_ZEROADJUST Dosino is halted in ZeroAdjust function
HOLD_ADJUST Dosino is halted in Adjust function
HOLD_TOENDDOS Dosino is halted in ToEnd function
HOLD_DOS Dosino is halted in MakeStep function
HOLD_PREPAR Dosino is halted in Prep function
HOLD_EMPTY Dosino is halted in Empty function
TIMEOUT Dosino is in timeout
UNDEFINED Dosino is in undefined status
2.1.3 Piston movement
enum eDirection
{
DIR_fwd =0,
DIR_rev =1
};
Moving directions of a Dosino piston.
fwd Forward, dosing (0 Æ 10000 pulses)
rev Reverse, filling (10000 Æ 0 pulses)
rv
fw