Gimbal, Gimbal controller unit, Screw pa – DJI H3-2D User Manual

Page 3: Gimbal video signal cable, Spare package

In The Box

Gimbal

The gimbal has built-in

special servos drive module

, and

independent IMU module. It controls both the tilt and the roll axis,

to enhance the attitude stabilization.

Damping Unit

Connect the aircraft and the gimbal, in order to reduce the

mechanical vibration. There are three types of Vibration Absorber,

the White is softest, the Black is hardest, and the Grey is in the

middle. It is recommended to use the White on

DJI

F450, not use

any on

DJI

F550, and the

DJI

PHANTOM can use any type.

Gimbal Controller Unit

(GCU)

Connect the gimbal controller to the autopilot system by

CAN-Bus. And Use the 3S~6S power cable to supply power for the

GCU and gimbal.

Screw Pa

ckage ×1

M2.5x6.3: For fixing the camera to the gimbal.

M2.5x5: For fixing the gimbal to the damping unit.

M3x8 (with M3 nuts and M3 spacers): For mounting the damping

unit to the aircraft.

Gimbal Video signal Cable

×1

For the gimbal controller unit and your Wireless Video

Transmission Unit connecting, transmitting the video signal.

CAN-Bus Cable×1

Use CAN-Bus to communicate with the autopilot system.

8-Pin Cable×1

For the gimbal and the GCU connecting,

Spare Package

×1

Spare Screw