DJI H3-2D - Manual (Page 11)

©2013 DJI Innovations. All Rights Reserved.
11
STEP3. Video Signal Transmission
A wireless video transmission module is necessary for video signal accessing remotely.
Wireless Video
Transmission Module
Air End
Video Signal Port
GND(Black: )
Gimbal Video Signal Cable
Video Signal
GND
Disconnected
Video Signal(Yellow:AV)
Power Extra power supply
1. Respectively solder the Video Signal/GND cables to wireless video transmission module (Air End).
2. Plug the gimbal video signal cable head into the GCU Video Signal Port.
Notes
(1) Make sure to connect Wireless Video Transmission Unit to GCU first, then power on.
(2) The standard gimbal video signal cable is recommended. Make sure you solder the gimbal video signal
cable to the wireless video transmission unit correctly. And ensure the cables are insulated, to prevent
from short circuit.
Disconnected
Video Signal Cable(AV)
GND Cable
(3) Please refer to your wireless vedio transmitter module manual to supply power,
since GCU can't supply power for it.
Tips:
(1) Following diagram shows how video signal transit when gimbal working.
(2) If video signal access fails, please check each step.
Camera
System Port
Gimbal
Camera Interface
GCU
G8
AV signal
Wireless video
transmission module
Air end
8-Pins cable
Gimbal Video
Signal Cable
Wireless video
transmission module
Ground end
Wireless signal
Monitor
AV input
5.8G/2.4G/1.2G
Self-prepared by user
AV signal
AV signal
AV signal