DJI H3-2D - Manual (Page 2)

©2013 DJI Innovations. All Rights Reserved.
2
Warning & Disclaimer
No adjusting or amending is allowed to the H3-2D!!!
Before use, make sure to mount the camera to gimbal first, and then mount the
gimbal to aircraft. After this, you can power on the gimbal.
H3-2D is specialized for Camera and Lens before it leaves the factory. Please mount your camera to H3-2D when
get it. No adjusting or amending is allowed to H3-2D. Do not modify or add any other component/device (such as
filter, lens hood, etc.) to the camera; make sure to use the original battery; otherwise it may end up with worse
performance or even internal malfunction.
The gimbal can only work with Autopilot system specified by DJI Innovations (NAZA-M/NAZA-M V2/WooKong-M),
so as to ensure the highest stability and precision. Please download the corresponding assistant software and
upgrade the autopilot system MC firmware, otherwise may lead t he gimbal work abnormally.
Make sure the Autopilot system operates in the safest manner when the main power battery is connected. We
strongly recommend customers to remove all propellers, use power supply from R/C system or flight pack battery,
and keep children away during gimbal calibration and parameter setup. Please strictly follow these steps to mount
and connect gimbal on your aircraft, as well as to install the assistant software on your computer. Please respect
the AMA’s National Model Aircraft Safety Code.
As DJI Innovations has no control over use, setup, final assembly, modification (including use of non-specified DJI
parts i.e. motors, ESCs, propellers, etc.) or misuse, no liability shall be assumed nor accepted for any resulting
damage or injury. By the act of use, setup or assembly, the user accepts all resulting liability. DJI assumes no
liability for damage(s) or injuries incurred directly or indirectly from the use of this product.
DJI and H3-2D are registered trademarks of DJI Innovations Names of product, brand, etc., appearing in this
manual are trademarks or registered trademarks of their respective owner companies. This product and manual are
copyrighted by DJI Innovations with all rights reserved. No part of this product or manual shall be reproduced in
any form without the prior written consent or authorization of DJI Innovations. No patent liability is assumed with
respect to the use of the product or information contained herein.
Product Profile
This product is an excellent gimbal designed for AP . Excellent job can be done by this gimbal. The gimbal has
built-in slip ring in the mechanical structure, preventing wire rod from winding up. It also has built-in
independent IMU (Inertial Measurement Unit) module, special servos drive module, etc.