Calculated Industries 4095-B User Guide - Manual (Page 42)

42 —
P
IPE
T
RADES
P
RO
™
Horizontal to Horizontal
In the next example, the same box dimensions are used except
the exit fitting now creates a pipe exit horizontally instead of
vertically. The entry fitting angle of 43.44° and pipe length of
39 and 15/16 inches remain the same since the dimensions in
this example are the same (if they were different, steps 1 and 2
on the previous pages could be repeated to calculate them).
However, by re-orienting the box dimensions to show the
Advance on the same plane as the horizontal exit fitting
(Diagram 3), the exit fitting angle can easily be solved using the
Rolling Offset feature.
0’ -29”
Roll
0’ - 15”
Offset
0’ - 23”
Advance
Unknown
Exit Fitting
Angle
Diagram 3
KEYSTROKE DISPLAY
  0.
3. Calculate the exit fitting angle.
   
OFST 15 INCH
   (Advance)
RUN 23 INCH
    (Roll)
LNTH 39-15/16 INCH
 FIT°
54.84°
The entry fitting angle is still 43.44°. However, the exit fitting
angle is calculated to be 54.84°.