Preference settings – Calculated Industries 4095-B User Guide User Manual
Page 15
U
SER
’
S
G
UIDE
— 15
PREFERENCE SETTINGS
HOW TO SET PREFERENCES
The following sections detail Preference Setting options for the
PipeTrades Pro calculator.
Enter the Preference Mode by pressing
(Prefs).
Access each category by pressing the
key until you reach
the desired setting. Within each category, press the
or
keys to toggle between individual selections. Press to
exit and set your Preference.
Note: Press
to advance and press to back up. Pressing
the
key continuously in this mode will cycle through all of
the Preference Settings.
You may change these settings at any time by repeating the
above, and setting in a new preference.
To reset preferences back to factory default settings, turn your
calculator off, hold down the
key and turn the calculator
back on.
For example, if you wish to display all your dimensional area
answers in square meters, press
(Area Std),
then the
key until “AREA 0. SQ M” is displayed. Simply exit
this mode by pressing
and all your future area answers
will be displayed in square meters.
KEYSTROKE
DISPLAY
(Fractional Resolution)
FRAC 0-1/16 INCH
FRAC 0-1/32 INCH
FRAC 0-1/64 INCH
FRAC 0-1/2 INCH
FRAC 0-1/4 INCH
FRAC 0-1/8 INCH
(repeats options)
FRAC 0-1/16 INCH
(cont'd)