Calculated Industries 4095-B User Guide - Manual (Page 27)

U
SER
’
S
G
UIDE — 27
USING THE PIPE TRADES PRO
Pipe Material Key
The Pipe Material key lets you choose a pipe material, which
defines the available sizes and surface roughness used by the
calculator. See Appendix A on page 53 for more information.
The default material for the Pipe Trades Pro is Steel, but the
user can choose from material types as shown.
KEYSTROKE DISPLAY
 
0.
 (Steel)
MATL StEEL
 (Stainless Steel)
MATL S.StEEL
 (Brass)
MATL brASS
 (Aluminum)
MATL AL.
 (Cast Iron)
MATL CASt
 (Plastic)
MATL PLAStIC
 (Copper)
MATL COPPEr
The last material setting displayed is selected, and the
calculator will retain your setting even after the power has been
turned off. Once a material is selected, you can easily toggle
through the available types (Schedules, etc.) using the Pipe
Type function (
  ). Available types of pipe are dependent
upon the material setting.
Keystrokes below show the pipe types available for Plastic
(press
 until “PLAStIC” is shown in the display).
KEYSTROKE DISPLAY
  0.
 
MATL PLAStIC
  (Schedule 40)
TYPE 40 PLAStIC
(cont'd)