Calculated Industries 4095-B User Guide - Manual (Page 17)

U
SER
’
S
G
UIDE — 17
ENTERING DIMENSIONS
Linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing

(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.
Examples of how linear dimensions are entered (press

after each entry):
DIMENSIONS KEYSTROKE
5 feet
 
5 feet, 1 ½ inches
      
17.5 meters
     m
1250 millimeters
    m
Square and Cubic Dimensions
Examples of how square and cubic dimensions are entered
(press

after each entry):
DIMENSIONS KEYSTROKE
14 square inches
   
11 square feet
   
3.3 square meters
    m m
3 cubic feet
   