Units, Start acquisition, Stop acquisition – Bird Technologies VPM3 User Manual

Page 28: Max hold, Zero, Enable data logging, Logging settings, Figure 15 vpm, logging settings, View, Control panel

Units

Power -

Toggles the power measurement between Watts and Decibels.

Match -

Allows selection of match measurement units.

Note:

This is dependent on the sensor attached.

Start Acquisition

Starts a trace for the selected session.
Stop Acquisition

Holds a trace until a started again.
Max Hold
Holds and displays the highest trace data points.
Zero

Performs a zero calibraion on the selected sensor. See “Zeroing a Sensor” on
page 32.

Log

Enable Data Logging
Starts monitoring the selected Measurement type. See “Logging” on page 30.
Logging Settings
See “Logging” on page 30.

Figure

VPM, Logging Settings

View

Control Panel
When selected, it will display the control buttons.
Playback Controls

When selected, it will display the playback controls.