Bang & Olufsen BeoCom 5 - User Guide - Manual (Page 22)

Make and answer calls
The key on the handset is used to start and end a call. During the
call, the handset displays the duration of the call, the number or
name of the person called, and if you have two phone lines, also
the active line. If you do not wish to answer a call, you can mute
the ringing signal with the C key.
To make a call …
If you have two phone lines, the current line for
outgoing calls is indicated in the display as seen
in the illustration on this page. If you wish to use
another line, press the appropriate line key
Enter the phone number
To correct a digit, turn the wheel to move the
cursor to the digit and press C to delete it
Press to make the call. The call time is shown,
and if the name is stored in the Phonebook, this
is shown as well
Press to end the call. Alternatively, place the
handset in the charger
To answer a call …
Press to answer the call
Press to end a call. Alternatively, place the
handset in the charger
To mute a handset’s ringing …
Press to mute the ringing signal for the incoming
call.
>> Daily use
If you have two phone lines and
select a primary line for outgoing
calls, as described on page 40, this
line is accessed when you press .
If you have not selected a primary
line, the line last used for an
outgoing call is accessed.
If you end a call to or from a
number not previously stored in
the Phonebook, the display
prompts you to do so. Refer to
‘Store a number after a call’ on
page 27 for more information.
To get a dial tone before entering
the number, press .
L 1 or L 2
0 – 9
98765432 |
98765 | 432
C
98765432
0:19
23456789
0:02
C
22