Bang & Olufsen BeoCom 5 - User Guide - Manual (Page 11)

Troubleshooting via the display
If conditions exist which impede or otherwise affect the optimal use of
your phone, an alert appears in the display while the handset is in
standby and remains as long as the conditions apply.
An alert appears in the display* 3 …
> Turn the wheel to highlight other conditions if they apply.
> Press
OK to be able to adjust relevant settings, if available.
> Turn the wheel to adjust settings, and press OK to store them.
Messages in idle mode:
The handset is not registered to a base. Press OK
to start the first-time setup procedure.
There is no contact between the base and the
handset.
There is no connection between the base and
the phone line. This alert is only available if you
use the handset with a BeoLine 2 or a BeoLine
base.
The battery needs to be recharged.
The clock has not been set in the system. Press
OK to bring up the Time and date menu.
When this symbol appears in idle
mode the line is busy.
Register handset
to base?
Base not found
No dial tone
Recharge battery
The clock is not
set
11
* 3 If you do not wish to view the
alert, press .