Bunn DUAL GPR-DBC WITH SMART FUNNEL 41343 - Manual (Page 14)

Page 14
FRESHNESS TIME
This function activates a timer to provide a
visual indication that the dispensed beverage has
reached it's maximum hold time. All batch indicators
on that side will flash when time expires.
NOTE: Flashing can be stopped by pressing any
batch switch on the side activated, or by turning
warmer off.
Procedure for setting auto warm shut off:
1. Press and hold upper right hidden switch until
the display reads UNITS. Press and release upper
right hidden switch until the display reads FRESH
TIME.
2. Using (-) and (+), set the amount of time the
warmers are to be on before activating the alert.
3. Press DONE to store the programed time. The
display should now read SET NEW RECIPE.
4. Press and release the ON/OFF switch (either on
DUAL brewers) located on the front switch panel
to exit the FRESH TIME function and return to the
MAIN SCREEN.
FRESH TIME: OFF
(-) DONE (+)
P3262
10. Using (-) and (+), set the percent of heat to be
applied to the warmer.
11. When finished, press the center program switch.
The display should now read 3rd ON TIME on
SINGLE brewers, (< - < - 3rd ON TIME on DUAL
brewers).
12. Using (-) and (+), set the amount of time the warm-
ers are to operate.
13. When finished, press the center program switch.
The display should now read 3rd ON POWER on
SINGLE brewers, (< - < - 3rd ON POWER on DUAL
brewers).
14. Using (-) and (+), set the percent of heat to be
applied to the warmer.
15. When finished, press the center program switch.
The display will read FRESH TIME on SINGLE
brewers, (1st ON TIME - > - > on DUAL brewers).
16. On DUAL brewers, repeat steps 4 thru 14 for right
side warmer.
17. Press and release the ON/OFF switch (either on
DUAL brewers) located on the front switch panel
to exit the WARMER CONTROL function and return
to the MAIN SCREEN.
PROGRAMMING THE BREWER (cont.)
WARMER CONTROL (SETTING THE HEAT INTENSITY
AND PROGRAMED TIME) (cont.)
41343 120710