Bunn DUAL GPR-DBC WITH SMART FUNNEL 41343 - Manual (Page 13)

Page 13
AUTO WARMER SHUT OFF (SETTING THE AUTO
WARMER TO OFF OR A PROGRAMED TIME)
This function allows the warmers on the brewer to
be programed automatically shut off after a set time.
When the timer expires the batch lights on that side
will begin to flash to indicate the warmer(s) have shut
off.
NOTE: Flashing can be stopped by pressing any
batch switch on the side activated, or by turning the
warmer back on. Turning the warmer back on reacti-
vates the timer.
Procedure for setting auto warm shut off:
1. Press and hold upper right hidden switch until the
display reads UNITS. Press and release upper right
hidden switch until the display reads WARMER
OFF.
2. Using (-) and (+), set the amount of time the
warmers are to operate.
3. When finished, press DONE to store the programed
time. The display should now read WARMER
CONTROL?.
4. Press and release the ON/OFF switch (either on
DUAL brewers) located on the front switch panel
to exit the AUTO WARMER function and return to
the MAIN SCREEN.
WARMER OFF: OFF
(-) DONE (+)
PROGRAMMING FUNCTIONS - (cont.)
P3261
41343 120710
WARMER CONTROL?
NO DONE YES
WARMER CONTROL (SETTING THE HEAT INTENSITY
AND PROGRAMED TIME)
This function allows the heat intensity and warm
time of the warmer(s) on the brewer to be adjusted.
When the timer expires the batch lights on that side
will begin to flash to indicate the warmer(s) have shut
off.
NOTE: Flashing can be stopped by pressing any
batch switch on the side activated, or by turning the
warmer back on. Turning the warmer back on reacti-
vates the timer.
Procedure for setting warmer control:
1. Press and hold upper right hidden switch until the
display reads UNITS. Press and release upper right
hidden switch until the display reads WARMER
CONTRL?.
2. Press and release NO. The display will read FRESH
TIME?
3. Press YES to proceed. The display should now
read 1st ON TIME on SINGLE brewers, (< - < - 1st
ON TIME on DUAL brewers).
4. Using (-) and (+), set the amount of time the
warmers are to operate.
5. When finished, press the center program switch.
The display should now read 1st ON POWER on
SINGLE brewers (< - < - 1st ON POWER on DUAL
brewers).
6. Using (-) and (+), set the percent of heat to be
applied to the warmer.
7. When finished, press the center program switch.
The display should now read 2nd ON TIME on
SINGLE brewers, (< - < - 2nd ON TIME on DUAL
brewers).
8. Using (-) and (+), set the amount of time the
warmers are to operate.
9. When finished, press the center program switch.
The display should now read 2nd ON POWER on
SINGLE brewers, (< - < - 2nd ON POWER on DUAL
brewers).