Autocue WinCueLT - Manual (Page 9)

User Guide WinCueLT WinCue LT Installation • 2
1 WinCue LT Installation
1.1 Hardware requirements
• WinCue LT runs on Windows 95, 98, 2000 and NT Workstation.
• The recommended minimum specification is a True Pentium 233MHz chip
with 64MB RAM; the more memory the machine has the better the scroll
output will be.
• A built-in video converter with dual-scanning video card is required in order for
the text to be prompted on screen and on the VGA output monitor.
• A Dongle and a Serial hand scroll control, both supplied by QTV, are
needed to run WinCue LT.
1.2 Pre-Installation
The optimum screen resolution for running WinCue LT is 800 x 600 dpi and 256
colors. If you do not use this screen resolution you may experience a jerky scroll
output. You must have the DONGLE plugged into the parallel port before you
start the installation.
1.3 Installation
The software is supplied on CD-ROM. To install WinCue LT use the following
steps:
What you do Comments/Prompts
1. Insert the CD-ROM into the
CD drive
2. Click Start and select Run
3. Type d:install.exe, click OK
and the install program will
begin