Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start User Manual
Page 7
Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012
7
Preface
Configure the network Complete tasks associated with configuring the DeviceNet network with RSNetWorx
for DeviceNet software,
such setting the node address for the DeviceNet scanner module your controller uses to access the DeviceNet
network.
This quick start uses a CompactLogix 5370 L3 controller with a 1769-SDN scanner module, and the tasks
described in
are done so with that controller and scanner module. We recommend that
you use those components and corresponding software files with this quick start.
If you use a different Logix5000 controller and DeviceNet scanner module and corresponding DeviceNet network
software files, you can complete the tasks in
but you must account for any software
differences.
Create an
RSLogix 5000 project
Project used with your Logix5000 controller that includes all required control system components. Your project
must include the DeviceNet scanner module used by your controller to access the DeviceNet network.
This quick start uses a CompactLogix 5370 L3 controller with a 1769-SDN scanner module, and the tasks
described in
and
are done so for that controller and scanner module. We recommend that
you use those components with this quick start.
If you use a different Logix5000 controller and DeviceNet scanner module and corresponding RSLogix 5000
software files, you can complete the tasks in
but you must account for any software
differences.
Table 1 - Required Tasks To Complete Before Using this Quick Start
Task
Description