Rockwell Automation SD3000 PLUS DC Drive Regulator - Manual

Installation Instructions
SD3000 PLUS DC Drive Regulator
Class 1 LED Product
!
ATTENTION: Hazard of permanent eye damage exists when
using optical transmission equipment. This product emits intense
light and invisible radiation. Do not look into module ports or
fiber optic cable connectors.
!
ATTENTION: Energized industrial control equipment can be
hazardous. Severe injury or death can result from electrical
shock, burn, or unintended actuation of controlled equipment.
Hazardous voltages may exist in the cabinet even with the circuit
breaker in the off position. Recommended practice is to
disconnect and lock out control equipment from power sources,
and discharge stored energy in capacitors, if present. If it is
necessary to work in the vicinity of energized equipment, the
Safety Related Practices of NFPA 70E, “ELECTRICAL
SAFETY FOR EMPLOYEE WORKPLACES” must be
followed. DO NOT work alone on energized equipment!
!
ATTENTION: The installation of the drive must be planned
such that all cutting, drilling, tapping and welding can be
accomplished with the drive removed from the enclosure. The
drive is of the open type construction and any metal debris must
be kept from falling into the drive. Metal debris or other foreign
matter may become lodged in the drive circuitry resulting in
component damage.
!
ATTENTION: An incorrectly applied or installed drive can
result in component damage or a reduction in product life.
Wiring or application errors, such as, undersizing the motor,
incorrect or inadequate AC supply, or excessive ambient
temperatures may result in malfunction of the system.
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.