Rockwell Automation FD86N Drive Systems Enclosure Hardware - Manual (Page 20)

2-6 Installing the FD86N Enclosure
Publication S-3062 – November 1997
Joining Control Enclosures to
Bulletin 2100 MCCs For multi-enclosure control lineups, you might need to join enclosure
sections in the field. Holes are provided in the end panels for this purpose.
To join the enclosure sections, install M6
×
16 or ¼-20
×
½
″
thread-forming
screws in at least twelve holes as equally spaced around the perimeter of
the enclosure as is practical. Join enclosures by inserting fasteners through
the clearance holes of the FD86N into the thread-forming holes in the MCC
enclosure. See Figure 2.5 for preferred joining configuration.
Refer to publications 2300-5.1, 5100-5.1, and 2100-5.5 for MCC
installation information.
Figure 2.5
FD86N Enclosure with End Plates for Connection to a
Bulletin 2100 MCC
: Preferred Joining Locations
Left End Right End
Back Front Front Back
Note: The Bulletin 2100 MCC must
have 1.5
″
high base channels.