Rockwell Automation 20D PowerFlex 700H/S Frame 14 Replacement Power Structures - Manual (Page 22)

22 PowerFlex® 700S and 700H Frame 14 Replacement Power Structures
Step 5: Installing the
Product Identification Label
on the New Power
Structures All frame 14 replacement power structures are shipped from the factory
without a product identification label on the drive. If you are installing the
power structures in a 700S drive, you should label it with the accompanying
PowerFlex 700S label. If you are installing the power structures in a 700H
drive, you should label it with the accompanying PowerFlex 700H label.
Step 6: Starting the Drive 1. Install the protective covers, screens and air flow plate on the drive.
Installation is in the reverse order of removal as indicated in Step 2:
Removing the Old Power Structures on page 3 .
2. Start up the drive. Refer to the Start Up procedures in the appropriate
publication:
– User Manual - PowerFlex 700S Drives with Phase II Control,
20D-UM006
– Programming Manual - PowerFlex 700H Drives, 20C-PM001
DC B US CONDUCT
ORS AND CAP
ACIT ORS
OPERA TE A T HIGH VO LTA GE. REM OVE PO WER
AND W AIT 5 MINUTES BEFOR
E SER VICING
DA NGER
!
OR