Rockwell Automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A - Manual (Page 11)

Setting the Drive Jumpers 2-1
C
HAPTER
2
Setting the Drive Jumpers
Before the drive can be mounted and wired, you must set the drive jumpers to match
your drive application.
2.1 Removing the Drive Cover
You must remove the drive cover to provide access to the drive jumpers.
Step 1. Place the drive with the six cover screws facing up.
Step 2. Remove the six M4 machine screws that hold the cover in place.
Step 3. Remove the cover.
Important: Note that the gasket inside the cover is glued to the inside of the cover. Do
not disturb the gasket.
!
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly. Component
damage may result if ESD control procedures are not followed. Failure
to observe this precaution could result in damage to the equipment.
Figure 2.1 – Location of Drive Jumpers
J
5
0
1
S1
J
1
J
3
J
2
J
4
S2
J
7
J
6
J
8
J
9
J
1
1
J
1
0
J
1
2
J
1
3
0
1
J
1
8
J
1
6
J
1
4
J
1
5
J
1
7
J
1
9
S3